Prvi 6.5x54mm Schoenauer (Mannlicher-Schoenauer) Brass Bag of 100

These worked great for me, 6.5 x 54 M.S. The brass for this older milsurp is a little hard to find.

Great source of brass for converting to 35 Rem.

I've always had good luck with ppu brass. It never disappoints.

Provide Partizan brass has always been reliable and of high quality, I use it in several calibers, never a problem!

Can't full size brass that is brand new. 6.5x54 MS new RCBS dies and good imperial sizing wax and it would pull the case head away from case. Way to big at the base of the cartridge. Would not recomend to anyone.I will ask for a refund if I can get one.Norma brass is the only way to go

I've shot Prvi ammo and reloaded it for my 30-06, 8x57 and 6.5x54 MS. I deburr flash holes and uniform primer pockets and a few primer pockets have been a little deep and don't clean-up completely some flash holes tight but even up on deburring, neck wall thickness is fairly uniform. Comparing it to Hornady brass in same calibers and loads there is slightly less case capacity and a slight increase in velocity, SD & ES are very similar, if your very picky you will discard a few more but at the price you can discard a lot more and still save money. accuracy is excellent. I broke in my new Rem 700 in 30-06/w Leupold 3-9X just installed bore sighted, using Prvi 165gr factory ammo, first shot 3-1/2" low 1/2" right made four minor adjustments after each shot and Fifth shot cut the center out of the X. I then but five in the X one ragged 3/4" hole. That was a clean dry barrel each shot. The Hornady superformance 165gr did not shoot as well