Prvi 7.62x25mm Tokarev Brass Bag of 50

Great brass at a reasonable price. Head and shoulders above their competitor.

Looked around for brass and couldn't find any but PPU again!! I thought that i was settling for this! I was very pleasantly surprised with the quality of this brass! I will definitely buy PPU brass again!

I've used this brass for several years with no problems at all. Great brass at a great price.

Excellent Quality. Primed them, expanded neck, added powder, seated bullet & crimped. No problem.

Finally back in stock. I now can reload Tokerav. I will stock up in the event of another shortage, thank you grafs

This is good value brass. I will purchase this again.

ppu brass works well

Excellent Products and Service. Thank You for being an American Supplier. May Christ continue to bless you and your families!
Respectfully,

I use PPU for several calibers. Even if this was not one of the few choices for 7.62x25, I would still buy. The fact it is very consistent, shipped quickly and priced competitively are all bonus.

I had trouble with the Lee tokarev dies but after swapping to RCBS 30 Mauser I haven't had a single issue with the brass.

Great brass. Excellent price. Ppu is always good all around

I can't find anything bad to say about this brass. It just works and it seems to be very good quality stuff. I wouldn't hesitate to buy more.

I purchased 7.62x25 brass in Starline which is normally very good and and I tried some of the Prvi Partizan brass which is about the same cost. As I was working up load to match the PPU factory ammo, the Starline brass case head swelled and after resizing them they looked like belted magnum cases. This problem starts to developed just over 1400 FPS, the Prvi Partizan brass was able to handle much hotter loads well over 1500 FPS with no case head expansion. Also note there were no pressure signs on the primers at all, no cratering around the firing pin dent and the primer edges were still slightly rounded, I used AA#9, AA#7 and Long Shot powders. The Prvi Partizan brass in this case is a better choice at least for this caliber.

Probably the only brass for TT guns.

It is my opinion PPU makes good stuff. I'm quite grateful this brass is available, and am looking forward to begin work on this load. .

It is such a shame to see the run on ammunition. I just bought a new caliber with my M57 and was grateful to find this brass in stock.

Seems to be pretty good brass so far. Fairly consistent and after one firing it looks and feels just fine. Time will tell how it will hold up long term.

Always good and consitant brass. Bag numbers always correct

Very nice and uniform. PPU brass will always be my choice when prices and availability warrants. Normalizing the neck tension is required when adjusting for proper bullet seating.