Inline Fabrication 4" Micro Quick Change Ultramount (includes Legs and QC Base Plate)

Inline Fabrication 4" Micro Quick Change Ultramount (includes Legs and QC Base Plate)

$74.99
Skip to product information
Inline Fabrication 4" Micro Quick Change Ultramount (includes Legs and QC Base Plate)
  • Inline Fabrication 4" Micro Quick Change Ultramount (includes Legs and QC Base Plate)
  • Inline Fab Quick change system
Inline Fabrication 4" Micro Quick Change Ultramount (includes Legs and QC Base Plate)

Inline Fabrication 4" Micro Quick Change Ultramount (includes Legs and QC Base Plate)

(SKU:IFULEGMC1)
MPN: ULEGMC.1
$74.99
Out of Stock - OK to Backorder

Quantity:

Ultramount Micro 4" has the same beefy 3\16" thick steel construction as the standard Ultramount, however, Micro is only 4" tall. Footprint is 9 1/4" wide by 9" deep.

(Note) With Ultramount Micro being only 4" tall, press linkages will hang below the benchtop to impede opening of cabinet doors or drawers (If you have them) below your bench. If you have any doubt, before placing an order, measure the linkages hanging down below your bench top and subtract 4".

Top plates sold separately.

Similar Products
  • 5 stars: 3 (100%)
  • 4 stars: 0 (0%)
  • 3 stars: 0 (0%)
  • 2 stars: 0 (0%)
  • 1 star: 0 (0%)
D
Dan Barnes
Inline fabrication mounting system

I wish I had done this earlier. Has to be one of the nicest mounting systems I've seen and the quick change is great. I would recommend this to anyone.

D
David Jones
Inline Fab 4" Ultramount w/quick Change Base

Should of bought one years ago. I have a small bench and like the ability to use different presses when needed.I have a rock chucker and a co-ax press. The rock chucker needs approx an inch overhang to clear the bench with the handle lowered. The the co-ax needs the same amount if you use the primer catch jar, without the jar the ultramount could be mounted farther back on the bench.

R
Robert Judy
Inline Fabrication Ultramount Micro 4"

Very well designed mount for many reloading tools.
This one is best for MEC Reloaders, case trimmers,
bench mounted priming tools etc.
Uses Quick Change Top Plates sold separately.
Great for the re loader with limited space.
Tools can be changed out in seconds.
They stay mounted to their specific top plate which comes pre drilled for the tool to be attached, Also comes with mounting hardware specific for the tool to be mounted to the top plate.
Prevents drilling extra mounting holes in your bench. A great addition to your loading bench.

Share: